Section 4: Accessories Installation
11Route the single connector end of cutter wiring harness (11, Figure
CAUTION: WHEN ROUTING THE WIRING HARNESS, ENSURE THAT IS
IS ROUTED IN A MANNER SO AS TO PREVENT PINCHING OR
INTANGLEMENTS.
5
5
5
4 | 7 | |
10 | ||
|
9 | 7 |
3 | 5 |
|
1
Figure 4-1b, Label Cutter Installation
12Connect wiring harness (11) to cutter assembly (12), main circuit board board (13), and power board (14).
NOTE: There is one small connector on the wiring harness that will remain unconnected for cutter installation. Ensure the connectors are properly oriented when mating. Equipment damage may occur otherwise.
13Attach cutter assembly (11) to the printer base by connecting their respective hinge halves.
14Remove two screws (15) securing cable shield (16).
15Encase cutter wiring harness (11) with the power cable in cable shield (16) and secure using two screws (15).
M84Pro Service Manual | PN: 9001111A | Page |