SATO M84PRO service manual MAINTENANCE/FACTORY Mode, ALL Clear Mode

Section 5: Printer Configuration

LCD DISPLAY	DEFINITION
DEFAULT SETTING	When the printer has completed the reset process it will beep 3 times and the
COMPLETED	Default Setting Completed display will appear. At this time the printer is in the
	default configuration.To exit the Default Setting Mode, power the printer off
	and then back on.

MAINTENANCE/FACTORY MODE

This function is used to clear counters and reset the printer’s firmware. It is also used after upgrading the flash firmware or installing a new memory module.

LCD DISPLAY		DEFINITION
MAINTENANCE MODE	Record all dip switch positions and place all in the OFF position.
DIPSW2-4 ON>OFF	1.	Place DSW2-4 switch in the ON position.
	2.	Press and hold the LINE and FEED keys while switching on the power.
	3.	Release the LINE and FEED keys when the printer beeps.
FACTORY MODE	4.	Place the DSW2-4 switch in the OFF position.
	5.	Press the FEED key to advance to the next display.
COUNTER CLEAR	6.	Use the LINE key to step the cursor to the desired option.
NONE	7.	Press the FEED key to select the option and advance to the next display.
PRINT SIZE	8.	Use the LINE key to step to the desired option (128 mm or 266 mm).
SMALL LARGE	9.	Press the FEED key to select the option and initiate test printing.
PRESS ENTER KEY	The FEED key may be pressed and repressed to start and stop printing
TO STOP PRINTING	at will.

ALL CLEAR MODE

This function is used to clear counters and reset the printer’s firmware. It is also used after upgrading the flash firmware or installing a new memory module.

LCD DISPLAY			DEFINITION
MAINTENANCE MODE		Record all dip switch positions and place all in the OFF position.
DIPSW2-4 ON>OFF		1.	Place DSW2-4 switch in the ON position.
		2.	Press and hold the LINE and FEED keys while switching on the power.
		3.	Release the LINE and FEED keys when the printer beeps.
FACTORY MODE		4.	Place the DSW2-4 switch in the OFF position.
		5.	Press the FEED key to advance to the next display.
ALL CLEAR MODE		6.	Press the FEED key to ENTER THE ALL CLEAR COUNTER EEPROM
			Mode.
ALL CLEAR		7.	Use the LINE key to step to the desired option (COUNTER).
COUNTER	EEPROM	8.	Press the FEED key to select the option and display the current value.
XXXXXXXALL CLEAR		9.	Use the LINE key to step to the desired option (YES) and ENTER to
YES	NO		select the option.
XXXXXXXALL CLEAR
COMPLETED

M84Pro Service Manual PN 9001111A Page 5-23