SATO M84PRO service manual Print Position Adjustment, Label Stock Diagram

Section 8: Adjustment Procedures

4 Turn the knurled knob of sensor adjustment shaft (2) to laterally adjust sensors (3) and (4).

NOTE: Adjust sensor to align with, and register; the label hole, notch, gap, or edge as applicable.

5 Close/install housing covers.

NOTE: Figure 10-1 in the Diagrams & Schematics section provides guidance on housing cover installation.

LABEL

EYE-MARK ON BOTTOM OF LINER

14MM MINIMUM

	LABEL
BACKING PAPER INSIDE EDGE	LABEL INSIDE EDGE
832	DOT COLUMN NUMBER	1
3MM	104MM
	EYE-MARK - 7 TO 54MM ADJUSTMENT
	LABEL GAP - 17 TO 64MM ADJUSTMENT

DIE CUT INTER-LABEL GAP 3MM NOMINAL

LABEL FEED DIRECTION

Figure 8-8, Label Stock Diagram

PRINT POSITION ADJUSTMENT

There are three methods of print position adjustment. Two of the methods allow for coarse adjustment, and the third permits fine adjustment.

Although there are three methods, only two are recommended for non-SATO personnel. For this reason, the VR1 potentiometer located on the main circuit board will only be identified here and not explained.

M84Pro Service Manual PN 9001111A Page 8-10