Section 5: Printer Configuration
Receive Buffer Selection(DSW2-5):Selects the operating mode of the receive buffer. Refer to the Interface Specifications section of this manual for more information.
| | | |
| DSW2-5 | SETTING | |
| | | |
| | | |
| Off | Single Job | |
| | | |
| On | Multi Job | |
| | | |
| | | |
If a 10/100BaseT LAN card is installed, DS2-5 has the following definitions:
| | | |
| DSW2-5 | SETTING | |
| | | |
| | | |
| Off | ENQ Response | |
| | | |
| On | Periodic Response | |
| | | |
| | | |
Firmware Download (DSW2-6):Places the printer in the Firmware Download mode for downloading new firmware into flash ROM.
| | | |
| DSW2-6 | SETTING | |
| | | |
| | | |
| Off | Disabled | |
| | | |
| On | Enabled | |
| | | |
| | | |
Protocol Code Selection (DSW2-7):Selects the command codes used for protocol control. Refer to the Selecting Protocol Control Codes section of the Technical Reference manual for additional information.
.
| | | |
| DSW2-7 | SETTING | |
| | | |
| | | |
| Off | Standard | |
| | | |
| On | Non-Std | |
| | | |
| | | |
M84Pro Service Manual | PN: 9001111A | Page 5-4 |
