SATO Complete Guide to Printer Configuration in the Official M84Pro Manual

Section 5: Printer Configuration

LCD DISPLAY		DEFINITION
IEEE1284		If the printer is placed in the Single Item Buffer Mode (DSW2-5 = ON), this
ACK SIGNAL	00.5	selection allows the width of the IEEE1284 ACK pulse to be set. In the Multi-
		Item Buffer Mode, this display will be skipped.The range is 0.5 µsec to 10
		µsec.
		1. Use the LINE key to step the display to the desired option. The setting will
		advance in increments of 0.1 µsec each time the CURSOR key is pressed
		until the setting reaches 10.0 µsec when it will wrap around to the 0.5
		µsec setting.
		2. Press the FEED key to select the option and advance to the next display
SERVICE MODE		The Service mode is exited by powering the printer off and then back on.

				COUNTERS MODE
The Counters Mode is provided to allow the user to access the internal printer cousters.
	LCD DISPLAY			DEFINITION
ADVANCED MODE			The Counter Mode is accessed from the Advanced Mode. Press the
			CURSOR keys to step to the Counter Mode.
COUNTERS MODE			Press the FEED key to advance the display to the counter selections.
COUNTERS			The counters are identified in the display as:
HD	CUT	LIFE	HD: Head Counter (should be reset when print head is replaced)
			CUT: Cutter Counter
			LIFE: Life Counter (cannot be reset)
			1.	Use the LINE key to step the cursor to the desired counter; Head (HD)
				counter or the LIFE counter. The default position is the Head Counter.
HEAD COUNTER			2.	Press the FEED key to select the desired option. The current value (in
		0.5M		meters) stored in the counter will be displayed. The maximum number of
				digits displayed is 8.
			3.	Press the FEED key again to advance the counter to the Clear mode. All
				counters with the exception of the LIFE counter will be cleared.
HEAD COUNT CLEAR			4.	Use the LINE key to select the desired option. If wanting to read the
YES		NO		counter value only, select NO. If wanting to read the counter and reset it to
				0.0, select YES.
			5.	Press the FEED key to return to the Counters Mode display.
COUNTERS MODE			6.	To exit the Counters Mode, turn power to the printer off and then back on.

M84Pro Service Manual PN 9001111A Page 5-21