SATO M84PRO service manual Slide entire print mechanism fully toward the rear

Section 4: Accessories Installation

5

6 4

	1	7	5
5	7		3

2

Figure 4-1a, Label Cutter Installation

7 Slide entire print mechanism fully toward the rear.

CAUTION: ENSURE WIRING HARNESSES ARE NOT PINCHED WHEN

ADJUSTING THE PRINT MECHANISM. THE PRINT MECHANISM WHEN

ADJUSTED, WILL COVER THE VOID LEFT BY THE REMOVAL OF THE

SPACER PANEL.

8Reapply two screws (7) to side frame bracket (8) and four screws (5) to back panel (6) to secure print mechanism.

9Attach two hinge halves (9, Figure 4-1b) to the front base of the printer using two screws (10) for each.

NOTE: Before tightening the hinge screws, pull the hinges forward to align them.

10Install spacer panel (4) into the void left in front of print mechanism and secure using two screws (3).

M84Pro Service Manual PN 9001111A Page 4-2