SATO M84PRO service manual DIP Switch Panels, RS232 TRANSMIT/RECEIVE Setting, Off

PRINTER CONFIGURATION 5

This section provides configuration instructions. Figures 10-7 through 10-19 in the Diagrams & Schematics section provides diagrams and charts on print operation sequence.

DIP SWITCH PANELS

There are two DIP switches (DSW2 and DSW3) located on the front panel under a protective cover. A third DIP switch is located on the RS232C Serial Adapter card and is used to set the RS232C transmit/receive parameters. Each switch is an eight section on/off toggle type switch. The ON position is always oriented upward and consequently, the off is always downward. Switch settings are read by the printer electronics during the power up sequence and will not become effective until the power is cycled.

RS232 TRANSMIT/RECEIVE SETTING

Data Bit Selection (DSW1-1):Sets the printer to receive either 7 or 8 data bits for each byte transmitted.

DSW1-1	SETTING
Off	8 Data Bits
On	7 Data Bits

DSW1

ON

OFF

1 2 3 4 5 6 7 8

Parity Selection (DSW1-2,DSW1-3):Selects the type of parity used for error detection.

			DSW1
DSW1-1	DSW1-3	SETTING
			ON
Off	Off	No Parity
			OFF
Off	On	Even
On	Off	Odd		1 2 3 4 5 6 7 8
On	On	Not Used

M84Pro Service Manual PN: 9001111A Page 5-1