SATO M84PRO service manual Software Default Settings

Section 5: Printer Configuration

Repeat Print via External Signal (DSW3-8):Allows the applicator or other external device to reprint the current label in the print buffer.

DSW3-8	SETTING
Off	Disabled
On	Enabled

DSW3

ON

OFF

1 2 3 4 5 6 7 8

DEFAULT SETTINGS

All switches are placed in the Off default position for shipping. This will result in the following operating configuration:

	DEFAULT SETTINGS
Communications	8 data bits, no parity, 1 Stop bit, 9600 Baud
Protocol:	Ready/Busy
Sensor	Gap Sensor
Receive Buffer	Multi Job
Mode	Batch/continuous
Label Sensor	Sensor Used
Backfeed	Enabled
External Signals	Enabled

SOFTWARE DEFAULT SETTINGS

The printer stores the software settings upon receipt and uses them until they are again changed by receipt of a command containing a new setting. These settings are stored in non-volatile memory and are not affected by powering the printer off. The printer may be reset to use the default software settings by depressing the LINE and FEED keys simultaneously while powering the printer on. This will result in the following default configuration.

	SOFTWARE DEFAULT SETTINGS
Print Darkness		3
Print Speed		6 Inches Per Second (3 for M84Pro-6)
Print Reference		Vertical = 0000, Horizontal = 0000
Print Offset		+0
Zero		No Slash
Ignore CR/LF		Disabled
Character Pitch		Proportional
Auto On Line		Enabled
Feed on Error		Enabled

M84Pro Service Manual PN 9001111A Page 5-7