Section 7: Replacement Procedures
CUTTER CIRCUIT BOARD REPLACEMENT
1Switch off the printer and disconnect the power supply cord.
2Remove cutter assembly (1, Figure
NOTE: If unsure how to remove the cutter assembly, refer to the Label Cutter Installation procedure in the Accessories Installation section for guidance.
3Disconnect all wiring harnesses from circuit board (2).
4Remove two screws (3) from paper guide plate (4).
NOTE: The two screws that are to be removed from the paper guide plate are located on the front side of the cutter along the lower perimeter of the plate.
CAUTION: WHEN THE TWO SCREWS ARE REMOVED FROM THE PAPER GUIDE PLATE, TWO NYLON SPACERS LOCATED BETWEEN THE CIRCUIT BOARD AND THE PLATE WILL BE FREED. ENSURE THAT THE CUTTER ASSEMBLY IS HORIZONTAL WITH THE CIRCUIT BOARD ORIENTED UPWARD WHEN THE BOARD IS REMOVED TO PREVENT THEIR LOSS.
5 6
2
7
A
D
B
| C |
2 | 8 |
| |
| C |
| D |
1
B | 3 |
|
A
Figure 7-24, Cutter Circuit Board Replacement
M84Pro Service Manual | PN: 9001111A | Page |