SATO M84PRO service manual DSW3 OFF

Section 5: Printer Configuration

Status Select(DSW2-8):For emulating earlier series software commands. Should be used only if problems are encountered when using existing software. This switch will also affect the settings selected by DSW1-7 and DSW1-8.

DSW2-8	SETTING
Off	Status 3 & 4 Enabled
On	Status 2 & 3 Enabled

DSW2

ON

OFF

1 2 3 4 5 6 7 8

Backfeed Sequence (DSW3-1,DSW3-2):Backfeed is used to correctly position the label for application and then retract the next label to the proper print position. This operation can be performed immediately after a label is printed and used, or immediately prior to the printing of the next label.

				DSW3
DSW3-1		SETTING
				ON
Off	Off	Continuous
Off	On	Tear-Off		OFF
On	Off	Cutter*
			1 2 3 4 5 6 7 8
On	On	Dispenser

*Defaults to Continuous if cutter not installed

Label Sensor Selection (DSW3-3):Enables or disables the Label Sensor. If the Sensor is enabled, it will detect the edge of the label and position it automatically. If it is disabled, the positioning must be under software control using Line Feed commands.

DSW3-3	SETTING
Off	Sensor Used
On	Not Used

DSW3

ON

OFF

1 2 3 4 5 6 7 8

M84Pro Service Manual PN 9001111A Page 5-5