Eureka 8860-8899 How to Maintain YourVacuum Cleaner, Maintain Brush Roll, Check Brush Roll Light

How to Maintain YourVacuum Cleaner

! Make sure vacuum cleaner is turned off and power cord is unplugged

Maintain Brush Roll

Motor can become hot with normal use.

Do not remove end caps. Remove hair and threads from brush roll periodically.

Check Cogged Belt. Replace if worn, cut or out of shape ! Avoid touching the motor shaft when checking brush roll or belt.

How to replace brush roll or belt		➀	➁
1)	Use handle release to lower handle
	flat onto floor. Turn vacuum over on its
	backside and remove 4 screws (Fig. 1).	➂	➃
2)	Turn vacuum over to front side and
	remove brush roll cover (Fig. 2).
3)	Remove brush roll and belt (Fig. 3).
4)	Thread new belt around motor shaft	Fig. 1	Fig. 2
	and then the brush roll (Fig. 4).
5)	Insert left end of brush roll first and
	then the right end (Fig. 5).
6)	Rotate brush roll 2 turns to center belt.
7)	Replace brush roll cover (Fig. 2). Turn
	vacuum over on its backside.
8)	Replace screws ➌&➍closest to
	the brush roll first. Then replace	Fig. 4	Fig. 5
	screws ➀&➁ (Fig. 6).

Fig. 3
➀	➁

➌➍

Fig. 6

Check Brush Roll Light

Turn vacuum off and unplug if ! indicator light turns on.

1)Remove debris that caused the brush roll motor to stall (Fig. 7).

Brush Roll Reset Button

1)Press reset button on the side of the brush roll cover to reset motor (Fig. 8).

2)Press top and bottom switches ON ( I ) and lower handle to vacuum carpet (Fig. 9).

Fig. 7

Fig. 8

Fig. 9

! Change Light Bulb

Make sure vacuum is turned off and power cord is unplugged.

1)Lower handle to floor and remove HEPA filter.

2)Unscrew the lens and remove old bulb. Replace with bulb rated 12v., 10w., Type 904 (Fig. 10).

3)Push in new bulb, replace lens cover and replace screw (Fig. 11).

4)Replace HEPA filter and return to upright position.

Fig. 10

Fig. 11

4 Eureka Customer Service HELPLINE 1-800-282-2886 www.eureka.com