Attach Charger Plug to Wall Bracket

CAUTION: Use only charger model 514 for 120 volt; model AD0412-SV1 for 230 volt.

Your vacuum cleaner has a special bracket designed	Charger Socket
to hold the unit, so that it may recharge while mounted
on the wall.

How to Mount your Vacuum Cleaner

Cleaner hangs in bracket with the nozzle end down. Mount on a wall where there are no dangerous objects hidden beneath the wall surface like electrical wires, pipes, etc.

1.Hold bracket against wall to mark location for screws. Make sure the wall bracket is positioned vertically, with the charger socket at the top.

2.Use a 1/4 inch drill for drilling holes for the plastic anchors.

3.Insert the anchors and drive the screws into both holes, leaving 1/4” of each screw exposed.

4.Place the bracket over the screws and slide the bracket downward to allow the screws to move into the slots.

5.Tighten the screws to secure the bracket.

6.Rest the cleaner on the docking ledge, with the nozzle pointed down, and push in on the top of the handle until you hear charger socket click into place.

7.Plug the charger into an electrical outlet.

Docking Ledge

Plug Charger

NOTE: Charge the cleaner for 10-12 hours before initial use. The batteries of a new cleaner are on a low charge.

Keeping your Vacuum Cleaner Ready for Use

Return your vacuum cleaner to the wall holder after every use. Firmly position into the mounting bracket ensuring that the vacuum cleaner fits correctly into the charging socket. It will then be recharged and ready for operation at all times.

The plug charger can be left in the electrical outlet at all times, even when the unit is in use. It is impossible to overcharge the batteries. The plug charger will become warm, however, this is not a cause for concern. The unit is charging when the red light on the top of the vacuum cleaner is illuminated.