Euro-Pro EP619 owner manual Cleaning the Hepa Filter and the Debris Screen

Fig. A

Wash once a month or when suction appears reduced

Warning: Allow 24 hours for drying before replacing in unit.

OPERATING INSTRUCTIONS

OPERATING INSTRUCTIONS

Cleaning the HEPA Filter and the Debris Screen

WARNING: After each Use - Always remove the Filter

Assembly, then vigorously “TapClean” HEPA Filter and clean Debris Screen until no more dust can be removed.

IMPORTANT, Please Note: The “TapClean” HEPA Filter will stop most of the tiniest dust particles and airborne allergens from re-entering the air you breathe. Because of this incredible filtration performance, the HEPA Filter will quickly accumulate, inside the white filter folds, many fine dust particles that are difficult to see but which will eventually block or reduce your suction power - if not cleaned properly.

1.To remove the filter assembly from the dust cup, hold the dust cup from the handle in one hand and with the other hand, turn counter clockwise and pull out the filter cover. (Fig. 14)

Fig. 14

3.Remove the HEPA filter from the debris screen. Remove the filter ring that is around the HEPA filter. Then

vigorously “TapClean” the HEPA Filter on a hard surface until no more dust is observed falling out.

4.To clean the debris screen, we recommend that you rinse it under lukewarm running water to remove the dirt that accumulates

on it, but always

allow 24 hours to air dry before inserting back into the vacuum.

5.To re-assemble the filter assembly, insert the filter ring over the HEPA filter and then insert the HEPA filter assembly into the debris screen. Insert the debris screen into the filter cover. Replace the filter assembly into the dust cup.

PLEASE NOTE: The white pleated filter material in the HEPA Filter will discolor over time -This is NORMAL and will NOT affect the performance

WARNING: Always remove the power plug from the wall outlet before assembling or removing accessories.

Inserting the Handle Into the Main Unit

•Insert the handle into the hole on the top of the unit. Make sure that the slot in the handle fits correctly into the opening. (Fig. 1)

•Insert the sleeve nut into the unit first. Then holding the sleeve nut with your thumb, insert the bolt. Using a flat screw driver, secure the bolt to the sleeve nut. (Fig. 1)

•To remove the handle, you have to remove the bolt and the sleeve nut.

Sleeve nut

Bolt

Fig. 1

Fig. 2

Floor Brush

Hose Connector

ATTACHING THE HOSE TO THE MAIN UNIT

•Hold the end of the removable hose handle and insert it into the hose connector. (Fig. 3)

2.To separate the filter assembly, hold the bottom of the debris screen and pull the filter cover out. (Fig. 15)

Filter Assembly

Filter Cover

HEPA Filter

HEPA Filter Ring

Debris Screen

Fig. 15

of the filter. If the HEPA Filter is properly "TapCleaned”

after each use and suction does not return to 100%, then we suggest that the HEPA filter be “TapCleaned” vigorously until no more dust can be removed,

then rinsed under the faucet and allowed to air dry for 24 hours before refitting into the vacuum. (Fig. A)

This should be done once a month or when suction appears to be

ATTACHING THE FLOOR BRUSH TO THE MAIN UNIT

•Insert the floor brush into its location at the bottom of the main unit, in the direction of the arrow. (Fig. 2)

•Make sure that the floor brush is firmly inserted into the floor brush socket.

•Insert the inlet hose into the floor brush hose connector that is on the floor brush. (Fig. 3)

•To remove the floor brush from the main unit, press on the floor brush release button and pull the floor brush out.

Hose

Connector

Fig. 3

Inlet

Hose

reduced .

Floor Brush

Hose Connector

7

4