Hoover Turbo POWER FoldAway Uprigh Cleaner Cleaning tools, Select proper tool, Remove hose

Cleaning tools

Tools allow for cleaning surfaces above the floor and for reaching hard to clean areas.

The cleaner is ready for tool use when handle is in upright position.

CAUTION: Agitator continues to rotate while cleaner handle is in upright position. Avoid tipping clean- er or setting it on furniture, fringed area rugs or carpeted stairs during tool use.

2-10

D

E

F

G

Select proper tool

D. Dusting brush may be used for carved furniture, table tops, books, lamps, lighting fixtures, venetian blinds, baseboards, shutters, and registers.

E. Furniture nozzle may be used for upholstered furniture, draperies, mat- tresses, clothing, automobile interiors, and carpeted stairs.

F. Crevice wand (stores inside exten- sion wand) can be used in tight spaces, corners and along edges in such places as dresser drawers, upholstered furni- ture, stairs and baseboards. It can also be used for extra reach with the dusting brush and/or extension wand.

G. Extension wand is used to give extra length to your hose. Use it with any of the above tools.

2-11

H

Remove hose

When using cleaning tools, cleaner handle should be in the upright posi- tion. Also, turn cleaner OFF before disconnecting and connecting the hose (H).

Remove hose end from cleaner base.

2-12

Attach wand and tools

The tools are attached to the hose or the wand in the same manner.

Push tool firmly onto hose; twist tool slightly to tighten or loosen connection.

Attach second wand or tool to the wand in the same manner.

2-13

I

Replacing hose

When you are finished cleaning with the tools, use the end of the hose to push the cover (I) down and push hose onto opening.

Twist hose end slightly to tighten the connector.

Extra reach hose

The extra reach hose provides easier cleaning of stairs and hard to reach places. Follow the steps below for attach- ing and detaching hose.

2-14

J

K

Turn cleaner OFF before disconnecting and connecting hose.

Remove hose end from cleaner base.

Align end of extra reach hose with projec- tions (J) with slots (K) on end of attached hose.

2-15

Slide hose into slots and twist hose to lock it into place. (To detach hose, reverse procedure.)

Attach wands or tools to the other end of hose.

6

How to clean tools

To clean the hose, wipe off dirt with a cloth dampened in a mild detergent. Rinse with a damp cloth.

Cleaning tools may be washed in warm water with a detergent. Rinse and air dry before using.