40
40For heavily soiled areas, it may be necessary to repeat the cleaning
process. Make crisscrossing strokes to the original pattern; overlap each pass.
Make no more than 2 passes with the solution over any one area to prevent
If additional cleaning is necessary, wait until the upholstery is completely dry before using the nozzle again.
Empty recovery tank when the motor sound becomes higher pitched and there is a loss in suction (see “Automatic
When finished cleaning, follow “After cleaning” instructions on page 9 and “After using tool” instructions on page 11.
S t o r a g e
Before storing:
•Empty solution tank and rinse thoroughly with clean water.
•Replace empty solution tank and turn deep cleaner ON. Squeeze trigger and push deep cleaner for- ward and back several times to expel any solution remaining in the deep cleaner’s system. (Do not use deep cleaner on wood floors.)
•Empty recovery tank and rinse thoroughly with clean water.
Allow underside of deep cleaner to air dry thoroughly before storing deep cleaner on a carpeted or wood surface.
Do not store deep cleaner with a full solution tank In place .
Lubrication
The motor Is equipped with bearings which contain sufficient lubrication for the life of the motor. The addition of lubri- cant could cause damage. Do not add lubricant to motor bearings.
Service
To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center or Authorized Hoover Warranty Service Dealer (Depot) by:
•checking the Yellow Pages under Vacuum Cleaners - Household” OR
•checking the list of Factory Service Centers provided with this cleaner OR -
•calling
•checking the Service section of The Hoover Company
Do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay.
If further assistance Is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720 Phone:
In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone:
Always identify your cleaner by the complete model number when request- ing information or ordering parts. (The model number appears on the bottom of the cleaner.)
12