Assembling Deep Cleaner
23
The assembled cleaner will look like this drawing.
A
Attach upper handle
2Remove clean solution tank (upper tank) from deep cleaner.
3 With cord hook (A) to back of deep cleaner, push upper handle down onto
lower handle. Push b o l t s into holes on f ront of handle. If bolts will not go
t h rough hole easily handle is not pushed c o m p l e t e ly dow n .
4 | 5 | 6 |
B
C
4Attach hose holder
Position hose holder (B) onto handle by matching tabs on rack with openings on back of handle. Make sure holes for bolts are aligned.
5Place nuts in recessed areas on back of handle. Hold each nut in
place while tightening each bolt securely (from the front of the handle) with a Phillips screwdriver.
Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience.
6When handle sections are com- pletely together, squeeze trigger (C)
on upper handle to snap trigger rod In place.
7 | 8 | 9 |
7 | Replace clean solution tank (upper | 8 | Press cord into cord clip on back of |
| tank) by positioning bottom first. |
| handle. Pull cord tight. |
|
|
Press on tank handle to snap top of tank into place.
4
9Attach tool holder
Remove tool and taped screw from holder.
Insert projections on rack into slots on back of cleaner.