D |
Replacing brush roll
Removing brush roll
Slide brush roll control (Fig.
Turn cleaner over and remove bottom plate (Fig.
Lift up brush roll and slide
E |
C |
Inspecting V-belt
The
Slide flat belt off large pulley as shown in Fig.
To remove
Discard used belt. Replace with Hoover belt part no. 38528034 (belt package part no. 40201200).
To install new belt (with lettering on out- side of belt), slide back of belt over pulley and pull front of belt toward groove (E) next to pulley. Belt will “pop” into place.
F |
Positioning belt on brush roll
Before positioning belt onto brush roll, check for debris accumulation as described in Fig.
Insert brush roll through belt and posi- tion belt in groove (F) on brush roll.
G | |
H |
|
Installing brush roll
Grasp brush roll and fit it into position by first sliding end, opposite the belt, into the rectangular slot (G) on side of cleaner.
Push other side of brush roll (H) into place. Belt may fit loosely when properly installed.
Reposition flat belt and bottom plate
(Figs.
Powered hand tool
Agitator brush roll replacement
When agitator brush roll brushes are worn, the brush roll should be replaced. Ask for HOOVER part No. 48414088.
A |
How to replace
1.Remove tool from hose and turn it so bottom faces up. Press the latches on either side of tool and remove bottom plate (A).
B |
2.Unscrew the two Phillips screws and remove belt guard (B).
11