To
Snap top of HEPA cartridge filter into place.
M |
L |
Align grooves (L) on
Slide filter assembly down into cup until a light snap is felt. Gently pull up on assembly to ensure that it is seated properly in the cup. Ensure that no part of
Close lid and return cup to cleaner (Fig.
Note: If dirt cup lid does not close all the way, first ensure that filter assembly is pushed down all the way. Then, turn knob on lid slightly until lid closes (see Fig.
N |
Final filter
Replacing final filter
The final filter assists in the filtration process to return clean air to the room.
To replace this filter when it becomes dirty, open the door on the side of the cleaner. Remove filter (N) and discard.
Reposition new filter on the side of cleaner. Make sure the white side of the filter faces outward. Close door.
Should you want to replace this filter, ask for part No. 40110006.
Do not operate cleaner without the fil- ter in place.
O |
Reattaching filter door
The filter door is designed with a
To reattach, align hinges (O) of cover with slots on sides of filter area.
Press door back into place.
Check brush roll channels
Because your cleaner picks up so well, we strongly recommend you check for debris accumulation in the channels next to the brush roll when you check the filters. Removing this debris will help maintain your cleaner’s excellent pick up and suction. Remove debris as follows:
Disconnect cleaner from electrical outlet.
Check for debris accumulation by removing bottom plate (Fig.
Remove any accumulation.
Reposition bottom plate (Fig.
Headlight replacement
What to buy
This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover part No. 27313101.
Removing lens
Disconnect cleaner from electrical outlet.
Using a screwdriver, remove the two screws as shown and lift off lens.
Installing bulb |
Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place
Excessive force is not required.
Replacing lens
Reposition lens and secure with the two screws.
Continued |
| 9 |
|