END PLATES
bbLOCATOR
END SECTION
Replacing the agitator brushes
Disconnect the cleaner from electrical outlet and disconnect power nozzle from extension wand.
To replace worn brushes, remove bottom plate, belt and agitator, following directions previously given.
Turn end plates of agitator counterclockwise until one end plate comes off.
Then pry out end section as shown.
Pry out opposite end section, removing the end plate and shaft from the agitator as illustrated.
Remove brushes by pulling them from agitator with pliers. Slide new brushes into the channels - small ends first - pushing them in as far as possible.
Replace end plate and shaft, lining up locator on end section with slot in agitator. Replace other end section and end plate and tighten.
Should you accidentally displace the bearing during disassembly, reassemble as shown.
18