Connect handle
Remove tank from
Join upper and lower handles, lining up holes. Place cord clip around cord with flat side toward handle and holes to front.
Insert bolt through cord clip and through small holes of handle; secure with nut. Pull up slack in cord and tight- en nut with screwdriver.
2. How to use
Polarized plug
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
ON-OFF switch
Attaching and removing brushes and pads
Disconnect from electric circuit before putting on or removing brushes.
Place
A
The floor machine’s
Start floor machine by pressing handle release lever and lowering handle. Raise handle to lock position to stop floor machine.
To attach brushes
Press each brush down firmly over brush shaft (A), rotating brush until it clicks into position. To
To attach pads
Insert end of fastener through opening in pad. Place pad over power scrub and cleaning brushes only.
The fastener fits around the brush shaft. Press the fastener to snap into place. Unsnap fastener to remove pad.
|
|
Attaching tank
Attach brushes and pads before attach- ing tank.
Set bottom of tank into tank support.
Turn tank cap lock until the rivet is directly above slot. Raise tank cap lock and tank cap. Snap tank against handle.
Push tank cap down. Slide cap lock down and turn right or left to lock tank and cap into position.
4