Storage
Wrap cord around cord storage hook located at the bottom of the tank hous- ing, and then around the trigger.
Store your floor machine in a cleaning closet or convenient place, ready for use. Hang it on the wall or remove brushes and store it with the handle in the upright position. Never store it on the brushes.
4.If you have a problem
If a minor problem occurs it usually can be solved quite easily when the cause is found by using the check list below.
Problem: Floor machine won’t run
Possible cause
Possible solution
•Not firmly plugged in
•Plug in firmly
•No voltage in wall plug
•Check fuse or breaker
•Blown fuse/tripped breaker
•Replace fuse/reset breaker
Problem: Floor machine won’t dispense solution
Possible cause
Possible solution
•Tank valve clogged.
•Unscrew cap on bottom of tank and rinse cap with water to clear blockage.
Problem: Floor machine does not glide easily
Possible cause
Possible solution
•Brushes and pads not properly attached.
•Attach brushes and pads properly.
•Accumulation of wax on felt pads.
•Wash and dry pads thoroughly.
Service
To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory Service Center
or Authorized Hoover Warranty Service Dealer (Depot) by:
•checking the Yellow Pages under “Vacuum Cleaners - Household” OR -
•checking the list of Factory Service Centers provided with this cleaner OR -
•calling
•checking the Service section of The Hoover Company
Please do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay.
If further assistance is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720 Phone:
In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone:
Always identify your cleaner by the complete model number when request- ing information or ordering parts. (The model number appears on the rear wheel cover.)
Servicing of double- insulated appliances
This appliance is double insulated. In a
Replacement parts must be identical to those parts being replaced. A double- insulated appliance is marked with the words 
may also be marked on the appliance.
Lubrication
The motor is equipped with two sleeve bearings. These bearings contain suffi- cient lubrication for the life of the motor. The addition of lubricant could cause damage. Therefore, do not add lubri- cant to either motor bearing.
9