To clean nozzle

If lint or other debris becomes lodged in nozzle, it can be removed for cleaning.

3-3

3-4

Unplug deep cleaner from electrical outlet.

Remove both tanks as described in Fig. 2-16. With handle in upright position, tilt cleaner back so that handle rests on the floor.

Lift up rear edge of nozzle. Slide nozzle up and remove from cleaner.

To replace nozzle, line up tabs (A) on nozzle with holes (B) in cleaner. Slide tabs into holes.

Slide nozzle completely onto cleaner. Press down on nozzle to secure it.

Replace recovery tank (Fig. 2-17).

The nozzle must be in the proper position in order for the recovery tank to go on properly.

Raise cleaner to upright position and replace clean water tank (Fig. 2-15).

Carpet Cleaning

Read “Before you begin cleaning” instructions on page 9.

1.Fill clean water tank according to instructions for Figs. 2-9 to 2-12.

2.Fill detergent container with HOOVER Carpet/Upholstery Detergent according to instructions for Figs. 2-13 to 2-15.

3.Turn brushes ON or OFF as desired.

4.Dry hands and plug cord into a prop- erly grounded outlet.

Do not clean over floor electrical out- lets.

5.To avoid walking on damp carpet, start at the end of the room farthest from the door or path to sink where tanks will be emptied and filled.

Step on handle release pedal and lower handle to operating position.

6.Set Wash/Rinse switch to WASH. Turn cleaner ON (Fig. 3-5).

3-5

FF	HSWA
O

ON	seniR

7.Squeeze trigger to release cleaning solution and slowly push deep cleaner forward (equals one wet stroke).

8.Continue to squeeze trigger and slowly pull deep cleaner back toward you (second wet stroke). Release trigger and slowly push deep cleaner forward over area just sprayed with solution (dry stroke). Then slowly pull deep cleaner back toward you without squeezing trig- ger (dry stroke). Continue using dry strokes until little water is visible passing through the recovery tank lid.

9.Overlap strokes by 1 inch to help pre- vent streaking.

Keep nozzle flat on floor for both for- ward and reverse strokes.

3-6

10.If rinsing the carpet is desired, set Wash/Rinse switch to RINSE (Fig. 3-7). Repeat steps 7-9.

Rinsing is not necessary, but will help remove detergent residue and help your carpet look fresher.

3-7
	FF	HSAW
	O	HSAW
ON	esniR
	esniR

11.For heavily soiled areas, repeat steps 6-9. Avoid saturating carpet, as noted below.

Note: To avoid saturating carpet, do not use more than 4 wet strokes over one area. Always end with dry strokes.

It is best to alternate wet and dry strokes as described above.

For best cleaning results and to aid in faster drying of carpet, end with more dry strokes. (Continue using dry strokes until little water is visible passing through the recovery tank lid.)

12.Empty recovery tank when the

motor sound becomes higher pitched and there is a loss in suction (see “Automatic shut-off”, Fig. 2-6).

When finished cleaning, follow “After cleaning” instructions on pages 9 &10.

Deep Cleaner Steam Vacuum specifications

The Hoover Deep Cleaner Steam Vacuum is a powerful home cleaning solution designed to tackle deep-seated dirt, stains, and odors in carpets and upholstery. Combining advanced technology with user-friendly features, this steam vacuum offers an effective way to maintain a clean and healthy living environment.

One of the standout features of the Hoover Deep Cleaner is its dual-tank system. This innovative design separates clean water from dirty water, ensuring that only fresh, hot water mixed with cleaning solution is used during the cleaning process. This method not only maximizes cleaning efficiency but also helps prevent muddy water from being redeployed onto carpets, thus providing a thorough clean.

The device employs powerful steam cleaning technology, harnessing the natural cleaning power of high-temperature steam to break down stubborn stains. The steam penetrates the fibers of the carpet, loosening dirt, grime, and allergens that traditional vacuuming may miss. This feature is particularly beneficial for households with pets, as it efficiently addresses pet-related messes and odors.

Equipped with a range of cleaning attachments, the Hoover Deep Cleaner is versatile enough to handle various surfaces. The upholstery tool is perfect for refreshing furniture and cushions, while the crevice tool can reach tight corners and hard-to-reach areas. This ensures a comprehensive clean throughout the home.

Moreover, the Hoover Deep Cleaner incorporates a heat-up feature that allows the water to reach optimal temperatures quickly, which enhances the efficiency of the cleaning process. This is complemented by powerful suction capabilities that not only extract dirt but also help in reducing drying times, making it more convenient for users who want to return to their normal activities promptly.

User ergonomics have not been overlooked. The vacuum is designed to be lightweight and easy to maneuver, ensuring that cleaning does not become a strenuous task. The handle is also adjustable, accommodating different user heights for optimum comfort during use.

Additionally, Hoover's reputation for reliability and durability is reflected in the build quality of the Deep Cleaner Steam Vacuum. The materials used are designed to withstand frequent use while remaining easy to maintain.

In summary, the Hoover Deep Cleaner Steam Vacuum stands out as a holistic solution for those seeking a deep cleaning tool that combines steam technology with user-friendly features. With its dual-tank design, powerful steam capabilities, versatile attachments, and ergonomic build, it ensures that cleaning carpets and upholstery becomes an efficient and effective endeavor.