Hoover U8315960 Using the cleaner, Power button, Surface Selector some models, Cord rewind

Using the cleaner

DO NOT USE CLEANER OUTDOORS OR ON DAMP OR WET SURFACES.

POWER button

A

Surface Command™ control dial (some models)

®￿

Surface Selector (some models)

9	The POWER button (A) is located
	at the top of the cleaner body.

Plug cord into electrical outlet.

To turn cleaner ON, press button once. To turn cleaner OFF, press button again.

NOTE: THE CLEANER IS SHIPPED WITH THE CONTROL DIAL IN HARD FLOOR POSITION. BEFORE YOU BEGIN TO CLEAN CARPETS, ROTATE THE CONTROL DIAL FROM HARD FLOOR TO A CARPET SETTING.

10 The Surface Command™ control dial (some models) is an automat-

ic height adjustment that allows you to choose a cleaning mode for carpet height or hard surface floors.

For maximum cleaning performance, the following carpet height settings are recommended:

Lowest setting: for all types of carpet,

Note: If the cleaner is difficult to push, turn dial to the next higher setting.

Higher settings: for very deep pile car- pet where easier pushing effort is desired, while maintaining good clean- ing performance.

HARD FLOOR The agitator brush roll is OFF; the nozzle is set at LOW.

11 The Surface Selector (some models) has three carpet height

settings and a hard floor setting. The Surface Selector turns to allow you to choose a cleaning mode for carpet height or hard surface floors.

For maximum cleaning performance, the following carpet height settings are rec- ommended:

Lowest setting: for all types of carpet,

Note: If the cleaner is difficult to push, turn dial to the next higher setting.

Higher settings: for very deep pile car- pet where easier pushing effort is desired, while maintaining good clean- ing performance.

HARD FLOOR MODE (with agitator brush roll shut off) the nozzle is set at LOW.

Automatic agitator brush roll shut-off

12	The agitator brush roll will turn off
	when the handle is in the upright,

storage position.

Agitator brush roll control

B

A

	OR
	A
A	B
13	Rotate control dial to “Carpet”
	settings (A) to turn agitator brush

roll ON for cleaning carpet or rugs.

Rotate control dial to “Hard Floor” (B) to turn agitator brush roll OFF when clean- ing hard floors.

Cord rewind

14	Grasp the end of the plug and
	pull to release cord from cord

reel. After desired cord length is reached, the cord will lock into position.

(Cont’d) → 07