Hoover Vacuum Systems owner manual If you have a p ro b l e m, Headlight re p l a c e N t

4 - 17

E

Replace brush roll cover (E) over agitator b rush roll. Replace 3 short scre w s .

4 - 18

Position hood on top of nozzle base.

Tu rn nozzle over. Replace 2 short scre w s at the back of nozzle and 2 long scre w s at the fro n t .

Agitator brushes and

brush roll re p l a c e m e n t

When to replace brushes

With CORDED hose,disconnect hose p ower cord from electrical outlet. W i t h CORDLESS hose,disconnect end of hose from electrified inlet va l v e.

4 - 19

When brush roll brushes are worn, the b rush roll should be re p l a c e d .

To check condition of brushes, move edge of a card across bottom plate while t u rning brush roll. To maintain cleaning

e ffectiveness, replace brush roll if bru s h e s do not touch card .

What to buy

When purchasing a new agitator bru s h roll, ask for HOOVER p a rt no.48414-071.

How to replace

With CORDED hose,disconnect hose p ower cord from electrical outlet. W i t h CORDLESS hose,disconnect end of hose from electrified inlet va l v e.

1. Remove hood, duct cover, belt and

b rush roll as shown in Figs. 4-10 to 4-15.

2.Discard old brush ro l l .

3.Replace new brush roll and belt as shown in Figs. 4-16 to 4-18.

Headlight re p l a c e-

m e n t

The headlight, located on top of the power nozzle, operates when the clean- er is turned on. Use only HOOVER part no. 27317-307, which is a fused bulb, when replacing the headlight.

4 - 20

How to replace

Disconnect cleaner from electrical outlet and disconnect power nozzle from extension wands.

1.Remove the hood as shown in Figs. 4-10 and 4-11.

2.Push old bulb into socket and twist to remove. Push new bulb into socket and twist into place.

3.Replace hood.

Edge groomer

replacement

When to replace

The edge groomers, located on both sides of the nozzle, should be re p l a c e d when they no longer extend past the sur- face of the bottom plate.

4 - 21

J

I

What to buy

When purchasing edge groomers, ask for Hoover p a rt no.39511004.

How to replace

Disconnect cleaner from electrical outlet.

1.Remove hood and b rush ro l l cover as shown in Figs. 4-10 to 4-13.

2.Pull off both old edge groomers (I).

3.Push each new groomer onto the 3 tabs (J), starting with one of the end tabs. Then push the groomer onto the middle and remaining end tab.

4.Replace brush roll cover and hood as shown in Figs. 4-17 and 4-18.

5.If you have a p ro b l e m

If a minor problem occurs, it usually can be solved quite easily when the cause is found by using the check list below.

Problem: Agitator brush roll

won’t run

Possible cause

Possible solution

•Hose power cord, nozzle power cord or cordless hose, not firmly plugged in.

•Plug firmly into receptacle.

•Broken or worn belt.

•Replace belt.

•Floor surface set to “BARE” in wrong position.

•Set floor surface to “RUG” posi- tion.

Continued ➜ 9