Replacement and Care of Filters
WARNING: To reduce the risk of shock or injury from moving parts, always unplug humidifier before removing or replacing any parts.
CAUTION: To help retard bacteria growth and keep maximum efficiency, the filter should be replaced at least once per season, or more often under hard water conditions. Use MoistAIR MAF2 recommended replacement filter.
Replace the evaporative wicking filter at least once per humidification season or more depending on water conditions in your area.
Filter Replacement
1.Unplug humidifier. Before removing the filter, we recommend moving the humidifier to an area where floor coverings are not susceptible to water damage. (i.e. kitchen or bath areas.)
2.Remove the water bottle and set aside. Be sure not to bump or damage the fill valve.
3.Grasp the housing assembly and lift straight up and away from the base and set aside. The filter is now accessible.
4.Take note of the filter position. Remove the filter. You may want to clean the base at this time. See the "Cleaning and Maintenance" section of this manual.
5.Install a new filter (MAF2) into the base. Coil the filter and position it between the uprights in the bottom of the base. The start and finish of the coil should be captured at the center of the base (see diagram) and the filter should be resting on the floor of the base.
6.Return the housing assembly to the top of the base. Reposition the humidifier to its operating position.
7.The humidifier is now ready to be filled for operation.
Grasp housing assembly 
securely and 
lift off 
Position start and finish of 
coiled filter at 
center of base
Align housing assembly bottom with top of base and reposition securely
10
