Hoover U57809RM owner manual Filters, Headlight

Filters (cont.)

Secondary Filter: How to Clean

Disconnect cleaner from electrical outlet. Do not use cleaner without dirt cup or filters in place.

4-8

A

Remove dirt cup as described in Fig. 4-2.

With thumb and forefinger, slide latch (A) located at the top of the housing to the right and pull down to remove gray filter frame. Remove black foam filter. Rinse filter frame cartridge and foam filter under cold water.

Allow both filter frame and filter to air dry for 24 hours before replacing filter into filter frame. Reposition filter frame cartridge by inserting tabs into slots on back of housing. Rotate filter cartridge frame up toward top of housing and snap closed.

Secondary Filter: What to Buy

When purchasing a new secondary filter cartridge, ask for HOOVER part No. 93002517. To purchase a new black foam filter, ask for HOOVER part No. 93002518.

HEPA Final Filter: How to Clean

Disconnect cleaner from electrical outlet. Do not use cleaner without dirt cup or filters in place.

4-9

A

With fingers in slots, pull filter frame (A) straight out.

Dirt and debris can be cleaned from the filter cartridge by brushing with the cleaner’s combination tool.

DO NOT RINSE OR WASH the HEPA filter cartridge.

Slide back into position on cleaner.

HEPA Final Filter: What to Buy

When purchasing a new HEPA filter cartridge, ask for HOOVER part No. 93002360.

Headlight

Disconnect cleaner from electrical outlet.

Removing Lens

4-10

Press handle release pedal and place handle in low position.

Using a Phillips screwdriver, remove the the screw as shown and lift off lens.

Headlight: What to buy

This cleaner uses a 13 volt, T-3 114 wedge base bulb, When purchasing a new lightbulb, ask for Hoover part No. 27313-107.

Installing Bulb

4-11

Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place.

Excessive force is not required.

Replacing Lens

4-12

Reposition lens and secure with the screw.

10