Questions and Answers

Timer	Changing the	Error Messages
	Message Display
	Language
		Error: #7
		Check
Normal. Timer: Auto	English	bumper
Normal. Timer: Auto	English	See manual
Select time?	Select language?	See manual
Select time?	Select language?

Should I pay attention to anything special when I vacuum a room for the first time?

It is a good idea to be present when the room is vacuumed the first time, for example to see if it takes unnecessary time for Trilobite to navigate around furniture.

Can I use Trilobite in a room with an activated alarm?

Yes, if it has a “pets monitoring” facility.

Can I hide the magnetic strips under e.g. a carpet?

Yes, as long as it not thicker than 15 mm.

Why does Trilobite sometime pause for approximately 10 seconds during vacuuming?

1.Trilobite uses two battery packs. It will briefly pause when switching from one battery pack to the other.

Why does Trilobite stop completely during vacuuming?

1.Check that it has been sufficiently charged. See page 24.

2.Did it find the charger during wall mapping?

3.The time duration for vacuuming may need to be increased. See page 28.

Why does Trilobite crackle while vacuuming?

Timer

It is possible to set the time duration for Normal or Quick vacuuming.

1.Select the desired vacuum programme and

press to confirm.

2.Use until “On” is displayed and confirm by pressing .

3.Set the desired time duration using and confirm by pressing . (For normal vacuuming, this is the time vacuuming lasts, i.e. not including wall mapping.)

4.Put Trilobite on the floor and start vacuuming by pressing .

Language

Trilobite can show display messages in English or Swedish.

1.To change the display language, switch on Trilobite and press .

2.The display will ask whether you want to change the programme. Ignore this and press .

3.The display will ask whether you want to change the time setting. Ignore this and press .

4.The display will ask whether you want to

change the language. Press .

5.Press to select the desired language

and confirm by pressing .

Trilobite will now show display messages in the selected language.

Status Messages

When you select a function, a status message is shown on the display for about seven seconds. After this, the name of the function is shown again. It is of course possible to change or confirm a displayed function even while the status message is shown.

Error Messages

The only faults that you can rectify yourself are the ones listed below. In the event of other error messages, recharge and restart your Trilobite. If it still does not start, contact our Customer Service on 020-53 53 50.

The errors you can correct yourself are presented below:

5. Check roller.

Is something stuck? Is it incorrectly attached?

6Check casters.

Is something stuck?

7Check bumper.

Verify its spring action. Is something stuck preventing it from moving?

12 Trilobite is stuck.

Move it and switch it on again. Also see Normal Vacuuming on page 4.

15 Check dust cassette.

In most cases, the filter unit has probably not been set or it is incorrectly set.

16 Check charger.

Is the charger connected to the mains? Are the terminals on the charger and Trilobite properly connected to each other?

21 Moisture on the circuit board.

Let the machine dry out for 12 hours. Then try restarting it.

What is the purpose of the audible signals?

They confirm that a command or measure has been correctly received or to advice a problem.

Trilobite operates at different speeds. Is something wrong?

Not at all. The speed varies depending e.g. on the layout and furniture in the room.

Is it all right to always leave Trilobite connected to the charger when it is not is use?

Yes, but make sure children cannot start it by mistake.

Is it necessary to switch off Trilobite before charging it?

No.

How can I know whether I have placed Trilobite correctly during manual battery charging?

A battery symbol lights in the display and you hear an audible signal.

Why doesn’t it charge?

1.Check that Trilobite is correctly connected to the charger (see the question above).

2.Check that the charger has been connected to the mains.

Is it dangerous to touch the charging terminals?

No. They have no power in the output mode and carry max. 28 V in the input mode.

This sound is produced by the navigation system.

Why do I need to replace the filter so often?

The filter is actually one of the most important components in the machine. It collects all dust, even very small dust particles (this is why you should also use original Electrolux filters). Just like a dust bag becomes full, so does the filter. There is no dust bag in the Trilobite, but the filter is always a necessity.

If Trilobite starts to smell bad, what could this be due to?

Probably the dust filter was not replaced.

What should I do when an error message is displayed?

The error messages you can correct yourself are shown on page 28. In all other cases, contact Customer Service by calling 020-53 53 50.

What is the Cable Protection System?

This is simply a system that prevents Trilobite from getting stuck in electric cords on the floor.

What is the Trilobite Stairsafe system?

This is a safety measure that prevents Trilobite from falling down staircases when they have been cordoned off with the magnetic strips.

Do I need to vacuum myself also?

Sometimes this may necessary no matter which vacuum programme you use, especially in corners or along the walls in the room.

8228226-02 specifications

The Electrolux 8228226-02 is a versatile and innovative vacuum cleaner that embodies the essence of modern cleaning technology. Designed for efficiency and ease of use, this model caters to a variety of cleaning needs, making it a popular choice for households and professionals.

One of the standout features of the Electrolux 8228226-02 is its powerful suction capability. Equipped with a high-performance motor, it ensures that dust, dirt, and allergens are effectively captured from different surfaces, including carpets, hardwood floors, and upholstery. This powerful suction is augmented by advanced filtration systems that trap even the tiniest particles, promoting a cleaner and healthier living environment.

The vacuum cleaner is designed with user convenience in mind. It features an ergonomic handle and a lightweight structure, allowing for easy maneuverability around the home. The 8228226-02 also comes with a range of accessories, such as specialized nozzles and brushes, optimized for cleaning various surfaces and crevices. This versatility ensures that users can tackle different cleaning tasks without needing multiple devices.

Another significant characteristic of the Electrolux 8228226-02 is its low noise operation. The manufacturers have engineered this model to operate at a reduced decibel level, making it ideal for use in noise-sensitive environments. This feature is particularly beneficial for households with children or pets, as it minimizes disruptions during cleaning.

In terms of design, the Electrolux 8228226-02 showcases a sleek and modern aesthetic. Its compact design not only saves space in storage but also makes it visually pleasing for contemporary homes. The dust container is designed for easy dust disposal, ensuring a hassle-free cleaning experience.

Moreover, the vacuum cleaner incorporates smart technologies, including automatic height adjustment. This function allows the cleaner to adapt to different floor types seamlessly, maintaining optimal suction power for each surface.

In summary, the Electrolux 8228226-02 stands out as a multifaceted vacuum cleaner that combines robust performance, user-friendly features, and modern design. Its powerful suction, advanced filtration, low noise operation, and versatility make it an excellent choice for anyone looking to maintain a clean and healthy living space. With this model, Electrolux continues to innovate and deliver quality solutions for everyday cleaning challenges.

Timer

Changing the

Error Messages

Message Display

Language