Electrolux 2100 manual Wand and Hose Assembly, Fig. a

Page 4

Wand and Hose Assembly

To install the power hose, align arrow (A) on hose with those on the suction end of cleaner. Insert hose until it clicks. To remove, press release tab (B) and pull hose out. Slip small accessories on end of wand or directly on hose handle and twist slightly to secure.

(A) Alignment

Mark

(B)Release Tab

Crevice tool for narrow spaces.

Shown for dusting.

Reversed for fabrics.

CAUTION: Turn cleaner OFF before connecting or disconnecting wands and power nozzle.

To assemble wand, insert the lower wand, large end first, into sheath until latches engage (Fig. A). NOTE: Before assem- bling wand, check that the electric cord connector at end of sheath is properly positioned in its receptacle (Fig. B).

Fig. A

Fig. B

To connect hose handgrip to the sheath wand, align electrical connections on underside of sheath wand and hose handgrip, and insert until latch clicks (Fig. C). To remove, press latch and pull wand out (Fig. D).

Fig. C

Fig. D

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents 2100 Important Safety Instructions Fill in and SaveDo not use outdoors or on wet surfaces Do not handle plug or appliance with wet handsIntroducing the 21OO by Electrolux Vacuum Cleaner FeaturesWand and Hose Assembly Fig. aOverheating Protection Information PanelOverheating Protection Operation Control knob when using the crevice tool Fig. NUse of Standard Attachments Using the Power Nozzle OFFTo replace air filters MaintenanceTo clear clogged hose Storage To replace filter bagsFilter bag is in place before operating the machine Using Sidekick optional accessory Limited 5 Year Warranty Service
Top Page Image Contents