Eureka 4320-4370 Series HOW to Assemble, Step B Attach Handle, Step D Check Disposable Dust Bag

Page 4

HOW TO ASSEMBLE (Continued)

Step B Attach Handle

CAUTION: Do not catch cord under handle.

Tab

5

Ledge

Groove 4

Groove

4.From rear of cleaner, align handle with groove and slide onto cleaner. If necessary, use thumb and finger pressure to slide handle into position.

5.Once handle is in place, check that the hose adapter tab is completely secure under the ledge of the handle.

6.Attach handle with two 5/8 inch screws in the assembly packet. Use either a slotted or Phillips® head screwdriver.

7.Replace front cover.

Step D Check Disposable Dust Bag

8.

Remove front cover,

 

 

 

grasp both sides of

 

 

 

 

 

 

bag cover near top.

8

 

Push thumbs against

 

center of cover and

 

 

 

pull out on sides.

 

 

9.

Check to be sure the

 

 

 

paper bag collar is

 

 

 

secure with the hose

10

 

 

adapter inside the

 

 

paper bag collar.

 

 

10.

Replace front bag

 

 

 

cover.

 

 

9

Hose Adapter

Paper Bag Collar

4

Step C Store Hose and Accessories

Combination

Tool

Hook

Crevice

Tool

Carrying

Handle

Extension Wand or Wands

HEPA Filter (on some models)

Tabs

Hose

Retainer

Step E Store Electrical Cord

11.You will find your cord retainer either at the bottom of the upper cord hook or on the handle above the upper cord hook. Firmly push the electrical cord down into either cord retainer. This will place the cord out of the way the next time you vacuum.

12.Next wind the cord around the two cord hooks on the left side of cleaner. On some models the upper cord hook turns to release the cord. Turn the hook up to store the cord.

NOTE: For easier access to bag compartment, when you store the electrical cord use a figure 8 pattern.

13. Secure the plug to the cord to prevent unwinding.

11

Cord

Cord

11

Retainer

 

 

 

Retainer

CordHook 12

12 Cord Hook

Image 4
Contents Upright Vacuum Cleaner Important Safeguards IndexService Information HOW to AssembleGeneral Information Thermal Cut OffHOW to Assemble Step C Store Hose and AccessoriesStep B Attach Handle Step D Check Disposable Dust BagCleaner Height Setting HOW to USEThermal Cut Off Dusting Side Upholstery How To Use AccessoriesCrevice Tool HOW to Maintain How To Replace Brush Roll BeltBrush Roll Brush Roll BeltHOW to Maintain How to Check and Clear Hose BlockagesDisposable Dust Bag and Filters To Remove BagHow to Check and Clear Hose How to Check and Clear Blockages in BaseTabs To remove Hepa cartridge filters To replace Hepa cartridge filtersTo Clean Motor Filter Motor FilterMicron and Hepa Exhaust Filters To Replace Micron or Hepa Exhaust FilterHOW to Maintain