HOW TO ASSEMBLE
CAUTION: Assemble the cleaner before using.
CAUTION: Moving parts, stay clear of brush roll when plugging in.
NOTE: Features may vary by model yet all parts assemble the same.
Step A Attach Hose
Hose Adapter
Bag Compartment
Tube Hole
1.To attach hose, insert the hose adapter into the bag compartment tube hole.
Step B Attach Handle
CAUTION: Do not catch cord under handle.
2
Groove
Step C Install Dust Bag (Some models may
have bag installed.)
6
6
7 |
| |
Bag | 5 | |
Collar | ||
Bag | ||
| ||
| Side |
8
5.Fold sides on new paper bag below bag collar.
6.Align bag collar hole and notch with hose tube.
7.Place rear of bag collar on ledges. Push back and rotate upward until firmly in place.
8.Make sure collar snaps into position and hose tube is securely inserted into bag collar hole. Tuck bag into bottom and along sides.
9.Align front cover tabs and close cover. Make sure paper bag is not caught under the front cover.
Step D Attach Bag Cover
Push to latch #
#Push
#
2.From rear of cleaner, align handle with groove and slide onto cleaner. If necessary, use thumb and finger pressure to slide handle into position.
3.Attach handle with two 5/8 inch screws in the assembly packet. Use either a slotted or Phillips® head screwdriver.
4.Lift up on the hose adapter to be sure it is secured.
10.Place front cover by aligning tabs at bottom of front cover into slots on cleaner. Pivot front cover toward cleaner and push firmly, gripping at the top of the bag cover, until latch is secure.
5