Check Rotating Floor Brush and Drive Belt

7. Check Drive Belt carefully for wear, cuts or stressed areas.

8. Check Air Passageway for obstructions. Remove debris from this area.

Replace Drive Belt

1. Unplug cleaner from electrical outlet.

2. With Rotating Floor Brush removed from vacuum cleaner (Steps 1-4 of check Rotating Floor Brush and Drive Belt), grasp old Drive Belt and remove from Motor Pulley.

Discard old Drive Belt.

3. Place new Drive Belt over Motor Pulley and stretch other end over Rotating Floor Brush in the space between the bristles.

4. Place ends of Rotating Floor Brush down into slots on sides as shown.

5. Turn Rotating Floor Brush by hand several times in the direction of Motor Pulley. If properly installed, Drive Belt will center itself on Rotating Brush crown.

6. Reposition Brush Cover and screws. Tighten screws securely.

Replace Lightbulb

1. Unplug cleaner from electrical outlet

2. Using a screwdriver, remove the two screws as shown and lift off the lens.

3. Remove the bulb from the socket by pushing in gently and turning it counterclockwise. Install the new bulb by pushing it gently into the socket and turning clockwise.

4. Reposition lens and secure with the two screws.

Maintaining Optional TurboBrush

Select Models Only

If a clog is present, unscrew the two screws in the back of the TurboBrush to remove the faceplate and clear any obstructions.

Check Rotating Floor Brush and Drive Belt Continued

4. Grasp Rotating Floor Brush at both ends and lift.
5. Clean strings, hair and other debris from Rotating Floor	Motor Pulley
Brush, paying particular attention to brush ends.

6. Clean strings, hair and other debris from Motor Pulley and Drive Belt areas.