How To Use This Guide
This User’s Guide has been designed to help you get the most satisfaction from your BISSELL
Pay particular attention to the product diagram, assembly instructions, and part names. Locate and organize all parts before assembly. Familiarize yourself with the parts and where they fit. Following this User’s Guide will greatly enhance your ability to get the most performance from your BISSELL
How To Put It Together
WARNING:
Plastic film can be dangerous. To avoid danger of suffocation, keep away from babies and children.
The only tool you’ll need to assemble your vacuum cleaner is a screwdriver.
Attach Handle To Vacuum
1. Locate the vacuum Handle and remove the screw packet taped to the base of the Handle.
2.Stand the vacuum upright and slide the base of the Handle firmly into the grooves at the top of the vacuum body.
3.Check to be sure the Handle is fitted to the vacuum body. If there is a gap in front, continue to push firmly
until the Handle is flush.
4.Insert the two screws from the screw packet into the existing holes. Tighten securely with a screwdriver.
Attach Vacuum Hose and Tools
1.Position the Twist ‘n Snap™ Hose assembly on the vacuum and line up the tabs on the base of the hose
with the corresponding notches. Turn the Twist ‘n Snap Hose to the right to lock into place.
2. Slide the end of the Hose Grip onto the Hose Grip Base. Place the Hose into the Hose Clip.
NOTE: The Powerfoot will not operate effectively unless the Hose is firmly attached to the base.
5
2/2/06 4:12:11 PM