Empty Dirt Container | Tip: |
1.
2.
3.
4.
The Dirt Container needs to be emptied when the dirt reaches the “Full” line on the side of the Container.
Unplug cleaner from electrical outlet.
Slide the Lock ‘n Seal Lever to the "Unlock" position.
Grasp handle and pull the Dirt Container straight out to remove from vacuum.
Empty dirt into garbage container.
For maximum cleaning performance, check and clean or replace all filters
as suggested.
| Full Line |
Unlock | Lock Position |
Position |
|
Put the Dirt Container back in the vacuum and slide the
5. lever to the "Lock" position.
Note: The Dirt Container may be washed in warm water with a mild detergent. Make sure it is completely dry before using again.
Cleaning The Upper Tank & Filter
Use only BISSELL Replacement Filters in your BISSELL Cleanview.
Upper Tank Filter |
1.
The Upper Tank Filter can be reached by removing the
2. Dirt Container, reaching underneath the Upper Tank and turning the rim of the Filter Frame to unlock. Pull straight down to remove. Brush the dirt off the Louvers and Upper Tank Filter.
The foam Upper Tank Filter may be removed and hand
3. washed in cold water with mild detergent. Rinse well then air dry thoroughly before replacing.
The Upper Tank and Louvers may also be wiped clean
4. with a damp cloth.
Note: For easier access, the entire Upper Tank may be removed by turning the knob on the back of the cleaner to unlock and pulling the entire tank straight out.
Cleaning The Pre-Motor and Post-Motor Filters
Use only BISSELL Replacement Filters in your BISSELL CleanView.
HEPA Media | 32076 (Optional Item) |
W A R N I N G :
Do Not operate cleaner with damp or wet filters or without all filters in place.
1. | Unplug the cleaner from electrical outlet. | ||
|
| Filter | |
| The | Filter | |
2. |
| ||
It is located in the slide out tray underneath the Dirt |
|
|
Container. If the filter becomes dirty, pull out the tray, lift out the filter and clean.
8