Bissell 6585 Operation, Handle position, Powerfoot height adjustment, Transporting cleaner

Page 6

Operation

Attach vacuum hose and tools continued

7.Place the TurboBrush in the bracket by aligning the bottom of bracket with the opening of the brush roll and snap the TurboBrush into place.

Handle position

Press the handle release pedal with your foot to place your BISSELL PowerForce Turbo Bagless into one of three cleaning positions.

1.Upright- For storage and above floor cleaning with special tools.

2.Normal Cleaning- Press handle release pedal once. Use for most household floor cleaning tasks.

3.Low Cleaning- With the vacuum in normal cleaning position press handle release pedal again. Use for reaching under low furniture such as tables, chairs and beds.

Powerfoot height adjustment

The powerfoot/rotating floor brush on your BISSELL PowerForce Turbo Bagless can be adjusted to clean several floor surfaces.

NOTE: For optimal cleaning performance, adjust to the lowest practical setting. If your cleaner is difficult to push, adjust to the next higher setting.

1.Place handle in upright position.

2.Turn height adjustment knob to desired setting.

Lowest Setting - For bare floors.

Medium Settings - For short and medium pile carpets.

Highest Setting - For plush pile or Berber carpet.

3.Place the handle into the normal cleaning position and the powerfoot will adjust to the setting chosen.

NOTE: You may also adjust the setting while in the normal cleaning position.

Transporting cleaner

1.To move your cleaner from room to room, put the handle in the upright position, tilt the cleaner back on its rear wheels and push forward.

2.The cleaner can also be moved by using the carrying handle on the back.

16 w w w . b i s s e l l . c o m

ug110_4018_6585_1207.indd 6

1

2

3

CAUTION:

Before using your vacuum, make sure that the Dirt Container is in locked posi- tion and that all filters (Inner Circular, Outer Circular, Pre-Motor and Post-Motor) are in place. Do not operate your vacuum without these filters.

Tip:

Before cleaning under low furniture, check area first for objects that might harm the unit or block the vacuum hose.

Tip:

Your vacuum features a quick release cord wrap. To remove the power cord quickly and easily, rotate the upper cord wrap towards floor, and slip power cord from upper and Lower cord wraps.

Carrying Handle

8 0 0 . 2 3 7 . 7 6 9 1

12/19/07 10:04:51 AM

Page 5 Page 7
Image 6
Page 5 Page 7
Contents Warranty E R ’ S G U I D EW w . b i s s e l l . c o m Important Safety Instructions Product view Attach handle to vacuum How to use this guideAssembly Attach vacuum hose and toolsLowest Setting For bare floors Powerfoot height adjustmentTransporting cleaner OperationLoop power cord around cord wraps on side of vacuum cleaner Power cordTurn vacuum cleaner OFF Special toolsMaintenance and care Empty dirt containerEmpty dirt into garbage container Cleaning pre-motor filter 169Grasp the circular filters and pull straight up to remove Unplug the cleaner from electrical outlet Replacing the Hepa post-motor filterMaintaining TurboBrush Check rotating floor brush and drive belt Unplug cleaner from electrical outletUse only Bissell Style 10 Replacement Replace drive beltUnplug cleaner from electrical outlet Empty dirt container Replace light bulbClearing clog Troubleshooting Vacuum cleaner wont pick up dirtTools wont pick up dirt Vacuum cleaner difficult to push Visible dirt escaping from cleanerAuthorized service representative 1112 Replacement parts Bissell PowerForce Turbo BaglessItem Part No. Part Name 910Warranty Limited One Year WarrantyIf your Bissell product should require service
Top Page Image Contents