Bissell 6585 warranty 169, Cleaning pre-motor filter

Page 9

Maintenance and care

Cleaning the inner & outer circular filters

Use only BISSELL Style 12 replacement filters in your BISSELL PowerForce Turbo Bagless.

1.Unplug the cleaner from electrical outlet.

2.Remove the dirt container as described in the previous section. Grasp the filter cup located at the bottom of the dirt container and twist counterclockwise to unlock and remove.

3.Grasp the circular filters and pull straight up to remove.

4.Separate the outer foam and inner pleated circular filters. Wash each individually by hand in warm water. Mild detergent may be used if desired. Rinse well, then air dry thoroughly before putting them back together and replacing in filter cup.

5.The filter cup may be washed in warm water with a mild detergent. Make sure it is completely dry before reassembling with filters.

6.The upper tank and primary separator may also be wiped clean with a damp cloth. Reach underneath the upper tank and turn the rim of the primary separator to unlock. Pull straight down to remove.

Cleaning pre-motor filter

1.Unplug the cleaner from electrical outlet.

2.The pre-motor filter protects the motor from debris. It is located underneath the dirt container and filter cup in the center of the round part of the Lock ‘n Seal lever.

3.Remove the small round filter and any debris on top of it. Rinse well under warm water, then air dry thoroughly before replacing.

w w w . b i s s e l l . c o m

WARNING:

Do not operate cleaner with damp or wet filters or without all filters in place.

Pre-Motor

Filter

8 0 0 . 2 3 7 . 7 6 9 1

169

ug110_4018_6585_1207.indd 9

12/19/07 10:04:56 AM

Page 8 Page 10
Image 9
Page 8 Page 10
Contents E R ’ S G U I D E WarrantyW w . b i s s e l l . c o m Important Safety Instructions Product view Assembly How to use this guideAttach handle to vacuum Attach vacuum hose and tools Transporting cleaner Powerfoot height adjustment Lowest Setting For bare floors OperationTurn vacuum cleaner OFF Power cordLoop power cord around cord wraps on side of vacuum cleaner Special toolsMaintenance and care Empty dirt containerEmpty dirt into garbage container Cleaning pre-motor filter 169Grasp the circular filters and pull straight up to remove Unplug the cleaner from electrical outlet Replacing the Hepa post-motor filterMaintaining TurboBrush Use only Bissell Style 10 Replacement Unplug cleaner from electrical outletCheck rotating floor brush and drive belt Replace drive beltUnplug cleaner from electrical outlet Empty dirt container Replace light bulbClearing clog Troubleshooting Vacuum cleaner wont pick up dirtTools wont pick up dirt Vacuum cleaner difficult to push Visible dirt escaping from cleanerAuthorized service representative Item Part No. Part Name Replacement parts Bissell PowerForce Turbo Bagless1112 910Warranty Limited One Year WarrantyIf your Bissell product should require service
Top Page Image Contents