Features
This tool includes some or all of the following features.
1.On/Off button
2.Handle
3.Handle reset button
4.Nozzle
5.Charging indicator
6.Dust collector cover
7.Cover release button
8.Charging base
9.Accessory caddy
10.Crevice tool
11.Brush tool
Assembly
Accessories (fig. A & B)
These models may be supplied with some of the following accessories:
uAn accessory caddy for storing your accessories.
uA crevice tool (10) for confined spaces.
uBrush tool (11) for furniture and stairs.
Fitting the accessory caddy (Fig. A)
uPlace the edge of the charger base (8) on to the edge of the accessory caddy (9).
uInsert the brush tool (11) into the front of the crevice tool (10) then push the crevice tool into the accessory caddy.
(Original instructions) | ENGLISH |
Fitting the accessories (Fig. B)
uLift the handle (2) until it clicks into place. The nozzle
(4)will automatically lift at the same time.
uInsert the crevice tool (10) into the front of the nozzle
(4).Make sure that it is pushed fully in. If the brush tool (11) is required then insert the brush tool (11) onto the front of the crevice tool (10).
Use
uBefore first use, the battery must be charged for at least 24 hours.
uPlace the appliance on the charging base whenever it is not in use.
Charging the battery (Fig. C)
uPlace the appliance on the charging base (8)
uPlug in the charger. Switch on at the mains. The charging indicator (5) will be lit.
uLeave the appliance to charge for at least 16 hours. While charging, the charger may become warm. This is normal and does not indicate a problem. The appliance can be left connected to the charger indefinitely. The charging indicator (5) will be lit as long as the appliance is connected to the
Warning! Do not charge the battery at ambient tempera- tures below 10 °C or above 40 °C.
To open the appliance (fig. D)
uLift the handle (2) until it clicks into place.
The nozzle (4) will automatically lift at the same time.
7