!
!
!
!
120 Volt Machine Instructions For Connection To The Power Supply And The Electrical Ground
This machine must be connected to the electrical ground to protect the operator from electric shock. The machine has an approved power cord with three conductors and a plug with three terminals. Connect the plug to a receptacle that has three holes and is connected to the electrical ground. The green (or green and yellow) conductor in the cord is the ground wire. Never connect this wire to any terminal other than the ground terminal.
This machine uses a 120 volt AC 60 cycle electrical circuit. Make sure you have the correct frequency and voltage before connecting the power cord to an outlet. The machine has a plug as shown in Figure 1. If a receptacle connected to the electrical ground as shown in Figure 1 is not available, have one installed by an electrical contractor. Do not use an adapter.
WARNING: To reduce the risk of electric shock, protect the machine from rain. Keep the machine in a dry area.
WARNING: To reduce the risk of electric shock, always use a
WARNING: Do not cut, remove or break the ground pin. If the outlet does not fit the plug, consult your electrical contractor.
WARNING: Have worn, cut or damaged cords and plugs replaced by an authorized service person.
PLATE
SCREW
OUTLET
MUST BE
CONNECTED TO
THE ELECTRICAL
GROUND
GROUND PIN
GFCI Outlet
3