Setting
Power management
For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.
Select one of the following options:
Ready 1........... When the lamp has been fully cooled
down, the POWER indicator changes to green blinking. In this condition, the projection lamp will be turned on if the input signal is reconnected or any button on the side control or remote control is pressed.
Ready 2........... When 3 hours have elapsed since power
management has been carried out, the lamp will turn off and the power will switch off. The operations during the initial 3 hours are the same as for Ready 1.
Shut down ...... When the lamp has been fully cooled
down, the power will be turned off. Off ................... Power management function is off.
Timer............... If the input signal is interrupted and
no button is pressed for more than 30 seconds, the timer display with No signal appears. It starts the countdown until the lamp is turned off. Use the Point ▲▼ buttons to set the Timer (1~30 Min).
Note:
•Factory default is OFF: 5 Min.
•When the shutter is closed while the Power management function is working, the Power management function is released.
Direct on
When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to the wall outlet.
Note:
Be sure to turn off the projector properly (see “Turning Off the Projector” on page 24). If the projector is turned off in the incorrect sequence, the Direct on function does not work properly.
Power management
Timer left before Lamp is off.
63
