Setting
Picture in Picture
This function is used to project two images simultaneously by placing a separate small sub screen within or next to the main screen.
Use the Point ▲▼ buttons to select Picture in Picture and then press the SELECT button to display a dialog box. You can also display the dialog box by pressing and holding the PIP button on the remote control for more than 3 seconds.
( In P in P, the larger picture is main picture, and the smaller one is sub picture; in P by P, the left picture is main picture, and the right one is sub picture.)
User setting
Show the selected mode (Off/User
P in P/P by P
P in P: Provide the images of Main picture and Sub picture at the ratio of Screen aspect in the Screen Menu.
P by P: Provide the images of Main picture and Sub picture at the ratio of 4:3.
Main picture / Sub picture
Input……Select an input from Input
Source… Select an input source. The display varies depending on the selected input.
Size……… Select the display size. Main picture can be
changed between 10 and 100%, and Sub picture can be changed between 10 to 50% in increments of 10%. When P by P is selected in Mode, the projection size is fixed to 50%.
Position… Press the SELECT button at Position and the display position setting screen appears.
Use the Point ▲▼◄► buttons to adjust the display position of active frame indicated in white. The frame will disappear after 10 seconds or when the SELECT button is pressed.
Selecting the Main picture or Sub picture
During Picture in Picture mode, and being undisplayed On Screen Menu, press the SELECT button to select Main or Sub picture. (A red frame will be displayed on the selected picture.)
Switching Input and Source
When selecting Main picture or Sub picture, input and source can be set by pressing the INPUT button on the side control or INPUT 1/2/3 button on the remote control. Operation on the On Screen Menu is not necessary.
Picture in Picture | Status (Stored / |
| |
Selected | Free/ Adj..) of the |
Mode | selected mode. |
|
Note:
•When PIP is selected, screen is not available.
Position Menu
Active frame 
(White)
Center line
display
Note:
•The Picture in Picture function is not available depending on the input signals and the selected input terminals. Refer to List of Picture in Picture for details. (p.95)
•When the input signal(s) is/are incompatible, X mark will be displayed for 10 seconds on the Main/Sub picture.
57
