Appendix
List of Picture in Picture
o : Picture in Picture combinations are enabled.
x : Picture in Picture combinations are disabled.
Note:
•When the input signal(s) is/are incompatible, X mark will be displayed on the Main/Sub picture.
•Depending on the frequency or signal type of PC/AV input, the display resolution may be lowered or images may not be displayed on the Main/Sub picture.
<Display resolution is lowered when;>
•Inputting PC analog signals: Between
<Images are not displayed and X mark appears when;>
•Inputting PC analog signals: More than 162 MHz
•Inputting PC digital signals: More than 100 MHz
•Inputting AV digital signals: 1080p
<Picture in Picture is disabled when;>
• Inputting signal formats: WUXGA 1, WXGA+2, UXGA 2, UXGA 3, UXGA4,
Serial Control Interface
This projector provides a function to control and monitor the projector's operations by using the
Operation
1Connect a
2Launch a communication software provided with PC and setup the communication condition as follows:
Baud rate : 9600 / 19200 bps
Parity check | : none |
Stop bit | : 1 |
Flow control | : none |
Data bit | : 8 |
3Type the command for controlling the projector and then enter the "Enter" key.
Example
When you want to change the input to INPUT 2, Type 'C' '0' '6' 'Enter'.
Note:
The default of the baud rate is set to 19200 bps. If an error occurs in the communication, change the serial port and the communication speed (baud rate).
Note:
Enter with ASCII
95
