Sanyo PLC-HP7000L You cannot operate, Does not work, Wireless mouse, Indicators blink or, Light

Appendix

	– Power management function runs by initial setting. Check “Setting”
	section on page 63.
	– If you continue to use the projector without replacing the air filter cartridge
	and resetting the filter counter after the filter cartridge replacement icon is
	displayed, the power will switch off automatically approximately 10 hours
The power is turned off	after projection starts in order to protect the optical parts. After this, the
automatically..	power will switch off automatically 3 minutes after it is turned back on and
	projection starts. (See pages 71, 87)
	– Do not cover the ventilation slots on the projector. (See pages 4, 6)
	– Projector may be used in high ambient temperature environment. Make
	sure the temperature is not out of Operating Temperature (41˚F–104˚F
	[5˚C–40˚C]). (See page 77)
You cannot operate	– If the side control is locked at "Key lock" under "Security" of Setting menu,
	the side control is not available. Please check “Setting” section on page
with the side control..
	65.
	– Check the batteries.
	– Check if the RC sensor is set properly. (See page 62)
	– Make sure no obstruction is between the projector and remote control.
	– Make sure you are not too far from the projector when using the remote
	control.Maximum operating range is 16.4’ (5m). (See page 15)
The Remote Control	– Make sure that the remote control code conforms to the projector’s code.
	(See “SETTING” section on page 62.)
does not work..
	– Unlock the Key lock function for the remote control. (See page 65)
	– Wireless remote control does not work when the remote control cable is
	connected to the projector. (See page 15)
	– Check if the ON/OFF switch on the remote control is set to “ON.”
	– Make sure that the simple mode in the remote control function is set to Off
	(See page 62).
Wireless mouse	– Check the cable connection between the projector and your computer.
	(See pages 20, 31)
function does not
	– Check the mouse setting on your computer.
work..
	– Turn on the projector before you turn on the computer.
Indicators blink or	– Check the status of the projector with referring to “Indicators and projector
light..	condition” on pages 85-87.
appears on the screen	– Your operation is invalid. Operate correctly.
Unable to unlock the
Logo PIN code lock,	– Contact the dealer where you've purchased the projector or the service
Security key lock or	center.
Security PIN code lock..
Forget the Logo PIN	– Contact the dealer where you've purchased the projector or the service
code or Security PIN
	center.
code..

WARNING:

High voltages are used to operate this projector.. Do not attempt to open the cabinet..

If problems still persist after following all operating instructions, contact the dealer where you purchased the projector or the service center. Specify the model number and explain about the problem. We will advise you how to obtain service.

80