Setting

Simple mode

This function decides whether to activate the simple mode.

Off . . . Simple mode function is off.

On. . . . Only the simple mode buttons are active.

Note:

Warning icon and Simple mode : On message appear on the screen for about 4 seconds when press the button which is not the simple mode button.

Remote control

The eight different remote control codes (Code 1- Code 8) are assigned to the projector; the factory-set, initial code (Code 1) and the other seven codes (Code 2 to Code 8). The same code should be set on both the projector and the remote control. For example, operating the projector in Code 7, the remote control code also must be switched to Code 7.

To change the code for the projector:

Select a remote control code in this Setting Menu.

To change the code for the remote control:

Press and hold the MENU button and a number button (1-8) on the remote control for more than five seconds to switch among the codes. See “Remote Control Code” on page 16.

Note:

When different codes are set on the projector and on the remote control, no operation can be made. In that case, switch the code on the remote control to fit the code on the projector.

If the batteries are removed from the remote control for a long period of time, the remote control code will be reset.

RC sensor

Select a location of the infrared remote receiver of the remote control. See “Remote Control Receivers and Operating Range” on page 15 for details.

Both ....

Activate both the front and back receiver.

Front ...

Activate only the front receiver.

Back ....

Activate only the back receiver.

Simple mode buttons

Only these buttons are active when the simple mode is set to On. [ON,

STAND-BY, SHUTTER,

INPUT, MENU, AUTO

PC, SCREEN, SELECT (Mouse Pointer

included), L-CLICK, R-CLICK, P-TIMER, POINTER, PIP, ON-OFF switch] Number buttons (p.14) also become active only when setting the remote control codes

numbers or entering the PIN code numbers (pp. 56, 66).

62

Page 62
Image 62
Sanyo PLC-HP7000L To change the code for the projector, To change the code for the remote control, Simple mode buttons