Farenheit Technologies DVD-19 owner manual Reference, Troubleshooting Guide

REFERENCE

TroubleshootingGuide

Check the following guide for the possible cause of a problem before contacting service.

Symptom	Cause	Correction
No Power	The power cord is disconnected.	Plug the power cord into the battery outlet securely.
The power is on, but the	No disc is inserted.	Insert a disc. (Check that the DVD or audio CD
player does not work.		indicator in the display is lit.)
No picture.	The TV is not set to receive DVD signal	Select the appropriate video input mode on the TV so
	output.	the picture from the player appears on the TV screen.
	The video cable is not connected	Connect the video cable into the jacks.
	securely.
	The connected TV power is turned off.	Turn on the TV.
No sound.	The equipment connected with the	Select the correct input mode of the audio receiver so
	audio cable is not set to receive DVD	you can listen to the sound from the player.
	signal output.
	The audio cables are not connected	Connect the audio cable into the jacks securely.
	securely.
	The power of the equipment connected	Turn on the equipment connected with the audio cable.
	with the audio cable is turned off.
	The Digital Audio Output is set to the	Set the Digital Audio Output to the correct position, then
	wrong position.	turn on the player again by pressing the POWER button.
The playback picture is poor.	The disc is dirty.	Clean the disc.
The player does	No disc is inserted.	Insert a disc.(Check that the DVD, or audio CD indicator
not start playback.		in the display is lit.)
	An unplayable disc is inserted.	Insert a playable disc.(Check the disc type, color system
		and Regional code.)
	The disc is placed upside down.	Place the disc with the playback side down.
	The disc is not placed within the guide.	Place the disc on the disc tray correctly inside the guide.
	The disc is dirty.	Clean the disc.
	A menu is on the TV screen.	Press the SETUP button to turn off the menu screen.
	The Parental level is set.	Cancel the Parental function or change the parental
		level.
The Remote control does	The remote control is not pointed at the remote	Point the remote control at the remote sensor of the
not work properly	sensor of the player.	player.
	The remote control is too far from theplayer.	Operate the remote control within about 5m.
	There is an obstacle in the path of the	Remove the obstacle.
	remote control and the player.
	The batteries in the remote control are	Replace the batteries with new ones.
	exhausted.
The POWER button and	The buttons or screen holding	In this case unplug the power cord of the player,
the other buttons are not	error may occur by some discs.	and then plug in the power cord again.
operated.

-29-