Coleman 2300 Series manual Before You Go, To Set Up

Before You Go

Preparing Hot Water on DemandTM unit for initial use.

•Unpack your new water heater from the carton and make sure that all of the parts are included. If you find that one of the components is missing, please contact Coleman for a replacement. 1-800-835-3278 or TDD 1-316-832-8707.

5-Gallon Collapsible

Water Carrier

(#809A606T)

12 Volt Auto	110V/120 Volt Household
Recharger Cord	Recharger Cord
(Located in storage compartment of your	(Located in storage compartment of your
Hot Water on DemandTM unit)	Hot Water on DemandTM unit)
(#2300-4071)	(#2300-4081)

•Charge the battery. Plug either 12 Volt Auto Recharger Cord or 110V/120 Volt Household Recharger Cord into unit and the power source.

•Charging LED should come on. Allow eight hours to fully charge the battery. RED color indicates a charging battery. A GREEN color indicates a fully charged battery.

•Charge the battery before using your water heater for the first time (Fig. 1).

•Clean before first use. It is strongly recommended that you clean the heater prior to using for the first time. Follow the simple steps on page 6 before you leave home, and then clean at least once a year or when the hose becomes discolored with a white calcium build up.

Fig. 1

To Set Up

•Select a level, sturdy surface for your water heater. A picnic table or camp table is ideal. Do not operate Hot Water on DemandTM unit from a position directly on the ground. (This allows water to drain, preventing damage while the unit is off in freezing temperatures.)

•Fill the 5-gallon collapsible water container with water – use only potable drinking water. Never use water from a lake or stream that has not been purified. Do not run any other liquid through Hot Water on DemandTM unit.

•WATER CONNECTION

•Unwrap the pump hose from around the water heater.

•Place the water carrier at a level below the water heater for proper drainage.

•Screw the water pump to the opening of the water container & hand tighten.

•Lay the water container on its side so the pump is towards the bottom of the container (step 2).

•Make sure to rotate the pump where “THIS SIDE UP” is facing upward so pump will prime and water will flow.

Step 1: Screw the Pump onto the opening of the Water Container and Hand Tighten.

Step 2: Lay the Water Container on its side so the Pump is towards the bottom of the container.

You can also submerge The Water Pump into an open water container such as a cooler. (Cooler

4 not included.)