LIGHTING THE WATER HEATER
FOR YOUR SAFETY READ BEFORE LIGHTING
Warning: This gas water heater is designed to operate reliably and safely as long as the lighting procedure is followed exactly.
Make sure the water heater is filled with water and the water supply is on, otherwise serious damage to the vitreous enamel cylinder lining and plastic components may occur.
The installer must purge the gas line up to the gas control (refer to “Gas Inlet” on page 26), check all gas connections for leaks, gas supply pressure, test point pressure (refer rating label) and adjust burner aeration if necessary (refer to “Air Adjustment” on page 41).
transport clip
Note:
•621 275 indoor model - remove the transport clip from the flue damper housing.
•631 275 outdoor model - the front cover must be in place before the burner will operate. If the front cover is off when power is switched on, the system will enter
•A viewing window is provided to check burner operation on the water heater.
LIGHTING PROCEDURE
The water heater incorporates an automatic ignition system.
1.Switch on the electrical supply at the isolating switch to the water heater.
2.When the controlling thermostat registers heating is required, the hot surface igniter rod warms up for 20 seconds. The burner will automatically ignite.
3.If burner ignition is unsuccessful, a second and third
4.If the third
39