| |
Installation Instructions | |
|
|
Installation Instructions
Step 1: Install eye wash
1.Attach the eye wash to the tank outlet with pipe sealant (supplied by installer) (see Figure 1).
IMPORTANT: When attaching the eye wash to the tank outlet, hold the adapter (Item 3) with a wrench to prevent stripping. Failure to do so may damage the seal and cause leakage.
2.Attach the pressure gauge to the adapter on the pressure side of the tank with pipe sealant (supplied by installer) as shown in Figure 2 on page 6.
3.FOR OPTIONAL HEATER JACKET:
•Secure the pipe insulation and yellow jacket to the eye wash assembly.
•Wrap the heater belt around the tank at a height of four inches from the bottom of the tank and fasten securely.
•Connect the heat trace cable to the junction box.
•Slide the jacket up the side of the tank and pull the draw- string at the top of the jacket.
•Place the junction box in the pocket on the inside of the jacket.
Back View
Figure 1
Bradley Corporation • | 3 |