Using the PowerStar
WARNING
Do not use the unit if you think it may be frozen, as this could result in serious damage to the unit. Wait until you are sure that it has completely thawed out before you switch it on.
•Check that the power is switched on at the circuit breaker panel.
•Turn on the hot water faucet FULLY. The hot water temperature can be changed by adjusting the temperature dial on the bottom surface of the unit. (The dial adjusts the temperature typically between 95°F and 131°F. The factory sets the temperature dial at the lowest position.)
•There are internal safety thermal
•If the unit has been used recently, run the water through for a few seconds to let the temperature settle down. You may initially get a short burst of very hot water from the unit.
•If a second outlet connected to the unit is also turned on, the hot water will be shared between the two.
Installing the PowerStar
WARNING | IMPORTANT |
Do not install the unit in a room where there | Read entire instructions. |
is a chance of freezing. |
|
Check the pressure of the main water supply. To operate correctly, the unit needs the following running
pressures : Minimum: 15 psi (1 Bar) Maximum: 150 psi (10 Bar)
Securing the unit to the wall
Diagram 1 | A E115 Unit | AE125 Unit |
3