Fostex Speaker specifications Product Specifications, Cable and Wiring Information

Page 6

Product Specifications

Cabinet Dimensions

297mm (W) x 400mm (H) x 420mm (D) incudes heatsink 385mm (D) cabinet only - no heatsink

11 11/16" (W) x 15 3/4" (H) x 16 1/2" (D) includes heatsink 15 1/8" (D) cabinet only - no heatsink

Net Weight

16 Kg

35.3 Pounds

Cross Weight (includes all packing material)

18.5Kg

40.8Pounds

Subwoofer Frequency Response

Free Field Frequency Response: 20Hz ~ 70Hz

XLR Outputs Frequency Response

Low Frequency Cutoff : 65Hz (-10dB)

Subwoofer Phase

Phase switch : + and -

Amplifier Power

110Watts@1%

Amplifier Distortion

<0.002% THD @ 50 Watts / 4Ohm

Amplifier Signal to Noise Ratio

> 80dB

Power Requirements

US : 120VAC ~ 60Hz

EUR/UK : 230VAC ~ 50/60Hz

Power Consumption

US : 75 Watts

EUR/UK : 80 Watts

Driver. 8" Magnetically shielded

Product improvement may warrant a change of specifications, newer materials or cosmetics, Changes in specifications and features may be made without notice or obligations.

Cable and Wiring Information

Use high-quality, shielded cables to connect your mixing console, workstation or other source to your monitors. Foil-shielded cables, such as Beholden 8451, 8761, or 9501 should do quite well. Other high quality cables are available and those that incorporate better shielding will yield an overall higher noise rejection, lowering your systems susceptibility to external interference. Another important tip to keep in mind when wiring your system is to route all line level cables away from the AC and other power sources, this will reduce the probability of having AC hum emanating from your studio monitors.

 

 

XLR

TRS

RCA

HOT (+)

 

PIN 2

TIP

TIP

COLD (-)

 

PIN 3

RING

 

GROUND

)

PIN 1

SHIELD

SHIELD

SHIELD (

Product Cleaning Instructions

Prior to cleaning the PM0.5-Sub MKthe power must be disconnected from. Once the power has been terminated, cleaning can be accomplished using a damp (not wet) cleaning rad. Do not use any abrasive or chemically harsh cleaning fluids.

Regular dusting with damp rag cleaning will keep your product looking new for years.

p-6

Image 6
Contents PM0.5-Sub MK Safety Instructions Introduction UnpackingSetup Instructions Back Panel Overview XLR & TRS Combination InputsProduct Specifications Cable and Wiring InformationProduct Cleaning Instructions Declaration of EC Directive