American Water Heater 319339-000 warranty Helical Internal Heat Exchanger, Modular Blower

Residential Gas

High Efficiency Power Vent

6-Year Limited Tank/ 6-Year Limited Parts Warranty*

90% THERMAL EFFICIENCY CONTINUOUS HOT WATER VERSATILE POWER VENT DESIGN

• Today’s homes demand more hot water than ever before, and the 90% efficient power vent gas water heater offers unprecedented levels of performance to meet the need. The 50-gallon water heater delivers hot water output that rivals a 75-gallon atmospheric gas water heater. In fact, the fully condensing design is so advanced, it can deliver “endless hot water for showers”…a continuous flow of over 3 gallons per minute. * Yet it is easy to install, with height, diameter and installation requirements similar to standard power-vent units.

HELICAL INTERNAL HEAT EXCHANGER

• Positioned in the center of the tank, surrounded by water to virtually eliminate radiant heat loss from the chamber

• Achieves 90% thermal efficiency which saves money on operating costs compared to a standard 78% efficient gas water heater

• Spiral heat exchanger reduces the accumulation of lime scale; maintains higher efficiency performance over time.

POWER VENTS USING PVC PIPE

• Combined vertical and horizontal vent runs terminating through an outside wall, using Schedule 40 PVC pipe

• Can be vented vertically thru-the-roof or horizontally thru-the-wall

– 2” pipe, vents up to 25 equivalent feet

– 3” pipe, vents up to 65 equivalent feet

– 4” pipe, vents up to 128 equivalent feet

MODULAR BLOWER

• Equipped with 120 volt, 60 Hz electrical system (rating 5 amps or less), 6-foot cord with standard 3-prong connector

• 2” PVC pipe, elbows and condensate drain supplied to connect heat exchanger outlet to blower

• PVC Vent Attenuation Assembly (VAA) supplied

SIDE-MOUNTED HOT AND COLD RECIRCULATING TAPS

• Allows water heater to be installed as part of combination space heating/water heating applications or any system requiring a recirculating hot water loop, including radiant floor heating

INTELLI-VENT™** GAS CONTROL

• Equipped with nearly indestructible silicon nitride hot surface ignitor — no standing pilot

• Advanced electronics for more precise control of water temperature and easy-to-understand system diagnostics

COMMERCIAL GRADE GLASS LINING
• Provides superior protection against corrosion
• Protects all interior tank surfaces including inside and outside of helical heat exchanger	VG6250T76NV
TWO HEAVY-DUTY ANODE RODS
• Provides added protection against corrosion

GREEN CHOICE® GAS BURNER

•Patented “Eco-Friendly” design reduces NOx emissions by up to 33% and meets less than 40ng/j requirements for low NOx

CSA CERTIFIED AND ASME RATED T&P RELIEF VALVE

MAXIMUM HYDROSTATIC WORKING PRESSURE: 150 PSI

*3.07 GPM continuous flow, based on 65°F inlet water temperature, 110°F outlet temperature. **Intelli-Vent is a registered trademark of Emerson Electric Company

*For complete warranty information consult the written warranty of American Water Heaters found at www.americanwaterheater.com, or call (800) 456-9805.

Copyright© by American® Water Heaters 2010. All rights reserved. NRGSS01110

No part of this work may be reproduced or transmitted in any form or by any means, electronic or mechanical, including photocopying and recording, or by any information storage retrieval system, without permission in writing from American Water Heaters.