Genie GTH-644, GTH-844, GTH-842 manual Proper Load Chart USE

Page 23

GENERAL SAFETY

PROPER LOAD CHART USE

WARNING

NEVER raise a load and drive to position it. This can cause the machine to turnover. When placing a load, always move a loaded machine with the boom angle indicator (B) at 0 degrees

or less. When the machine is as close as possible to where theB load needs to be placed, set the parking brake, raise the load,

then place the load into position.

The load chart shows the operating limits of a properly maintained and operated machine. To use the load chart the operator must know the weight of the load and how far "out" and "up" it is to be placed. If the load is heavier than stated on the load chart, three options can be used:

1.Move the machine closer to the load so that the weight of the load will fall within the load chart specifications.

2.Divide the load into smaller pieces so that each piece falls into load chart specifications.

3.Get a larger machine capable of handling the load within specifications.

2 - 9

Image 23 Contents
Operator’s Manual Table of Contents Section Rough Terrain Fork Lift Safety Table of Contents Introduction Rough Terrain Fork Lift SafetyStandards Standards and SymbolsTraining and Knowledge SafetyOperators Responsibilities Managements Responsibilities Maintenance and Repair Operation Safety Rough Terrain Fork Lift Safety Rough Terrain Fork Lift Safety Rough Terrain Fork Lift Safety Section General Safety General Safety Accident Prevention General Safety ProceduresSafety Alert Symbol OperatorRefueling Welding PrecautionsHand Holds and Steps Fluids Under Pressure Hydraulic Safety Service Tires Safely USE Seat Belt Practice Safe MaintenanceBoom Safety Avoid Electrical Power Lines Jump Starting Jump StartingProper Load Chart USE Letter Visible 8000 lbs General Safety Section Controls and Instruments Controls and Instruments Operators Compartment Controls and InstrumentsJoystick Control Functions Joystick Control Functions Button Pushed LOW Service Brake Pressure Light Service BrakesParking Brake Frame Sway Control Hydraulic Pump Destroke Button GaugesTransmission SteeringFront Axle Differential Lock Controls and Instruments Section Operation Operation Operation Operation and Safety GuidelinesBefore Starting the Engine Starting the Engine Operation Before Operating the Forklift Operation Operation Operation Transporting a Load Operation Placing a Load Operation GTH-644, GTH-842, GTH-844 Operation Section Maintenance Procedures Maintenance Procedures Before Servicing General Safety PracticesFluid Under Pressure Scheduledmaintenance Daily MaintenanceCheck Hydraulic OIL Level Section Material Safety Data Material Safety Data Material Safety Data Sheets Msds Material Safety DataCalifornia California Proposition 65 Warnings